Supermicro SUPERSERVER 6014V-M4, User Manual

Page: 55 / 122

Chapter 5: Advanced Serverboard Setup
5-19
SCSI Termination Enable/
Disable
Jumper JA1 is used to enable or dis-
able termination for the SCSI connec-
tor. The default setting is open to en-
able termination. See the table on the
right for jumper settings.
Note: In order for the SCSI drives to
function properly, please do not change
the default setting (enabled) set by the
manufacturer.)
SCSI Term. Enable/Disable
Jumper Settings (JA1)
Jumper Setting Defi nition
Open Enabled
Closed Disabled
Alarm Reset
The system can notify you in the event
of a power supply failure. This feature
assumes that Supermicro redundant
power supply units are installed in the
chassis. If you only have a single pow-
er supply installed, you should close
this jumper (JPR1) to prevent false
alarms. See the table on the right for
jumper settings.
Note: this jumper is not used with the
6014V-M4.
Alarm Reset
Jumper Settings (JPR1)
Jumper Setting Defi nition
Open Enabled
Closed Disabled
Power Force On
Jumper JPF allows you to enable or
disable the Power Force-On function.
If enabled, the power will always stay
on automatically. If disabled (the de-
fault setting), the user must press the
power button to power on the system.
Power Force-On
Jumper Settings (JPF)
Jumper Setting Defi nition
Open Disabled
Closed Force-On