Supermicro SUPERSERVER 6011L, User Manual, Page: 37 / 112

Chapter 5: Advanced Motherboard Setup
5-3
5-3 Connecting Cables
Now that the motherboard is installed, the next step is to connect the cables
to the board. These include the data (ribbon) cables for the peripherals and
control panel and the power cables.
Connecting Data Cables
The ribbon cables used to transfer data from the peripheral devices
have been carefully routed to prevent them from blocking the flow of
cooling air that moves through the system from front to back. If you
need to disconnect any of these cables, you should take care to
keep them routed as they were originally after reconnecting them
(make sure the red wires connect to the pin 1 locations). The
following data cables (with their locations noted) should be con-
nected. (See the layout on page 5-10 for connector locations.)
l
IDE Device Cables (J23 and J24)
l
Floppy Drive Cable (J26)
l
Ultra 160 LVD SCSI Connector (JA1)
l
Control Panel Cable (JF1, see next page)
Connecting Power Cables
The P3TDLR has a 24-pin primary power supply connector desig-
nated "ATX Power" for connection to the ATX power supply. The
ATX Power connector also is keyed to accept 20-pin power connec-
tors if the power supply you are using has that type. See Section 5-
8 for power connector pin definitions.