Supermicro SuperServer 6011D, User Manual

Page: 76 / 102

S
UPER
S
ERVER
6011D
User's Manual
7-16
BIOS
[Resources Controlled By]
The Award BIOS can automatically configure all the boot devices and all Plug
and Play compatible devices. However, if this item is set to "Auto (ESCD)",
the user is not able to set the IRQ DMA and memory address, since the
Award BIOS will automatically assign the values to these fields. The settings
are "AUTO (ESCD)" and "Manual." The default setting is "AUTO (ESCD)."
[PCI/VGA Palette Snoop]
For best performance of the system, this item has been pre-set to "Disabled"
by the manufacturer. The settings are "Enabled" and "Disabled." The default
setting is"Disabled."
[Assign IRQ for VGA]
If "Enabled", the item allows the AwardBIOS to assign an IRQ for the VGA
devices. The settings are "Enabled" and "Disabled." The default setting is
"Enabled."
[Assign IRQ for USB]
If "Enabled", the item allows the AwardBIOS to assign IRQ for the USB
devices. The settings are "Enabled" and "Disabled." The default setting
is"Enabled."
[Reset Configuration Data]
If you have installed a new add-on device and this add-on device has
caused conflicts in system configuration and has resulted in system boot-up
failure, then, select "Enabled" to reset "Extended System Configuration Data"
(ESCD) for the OS to reboot the system. The settings are "Enabled" and
"Disabled." The default setting is"Disabled."
[PNP OS Installed]
Select "Yes" if you are using an operating system that supports the plug and
play solution. Select "No" if you need the BIOS to configure non-boot
devices. The settings are "Yes" and "No." The default setting is"No."