Supermicro SuperServer 5038MR-H8TRF, User Manual

Page: 60 / 133

5-12
S
UPER
S
ERVER 5038MR-H8TRF User's Manual
Other Connectors
Universal Serial Bus (USB)
One USB 3.0 header (USB1) is located the on the motherboard. There are also two
ports (USB 0/1) available through the KVM port. (Cables are not included.) See the
table on the right for pin definitions.
TPM Header
This header is used to connect a
Trusted Platform Module (TPM) that
is available from a third-party vendor.
A TPM is a security device that allows
encryption and authentication of hard
drives. It enables the motherboard to
deny access if the TPM associated
with the hard drive is not installed in
the system. The header is located at
JTPM1. See the table on the right for
pin definitions.
Trusted Platform Module Header
Pin Definitions
Pin # Definition Pin # Definition
1 LCLK 2 GND
3 LFRAME 4 No Pin
5 LRESET 6 VCC5
7 LAD3 8 LAD2
9 VCC3 10 LAD1
11 LAD0 12 GND
13 RSV0 14 RSV1
15 SB3V 16 SERIRQ
17 GND 18 CLKRUN
19 LPCPD 20 RSV2
SATA DOM Power
The SATA Disk-on-Module (DOM)
power on JSD1 is used to supply
power to solid-state storage devices.
DOM PWR
Pin Definitions
Pin# Definition
1 5V
2 Ground
3 Ground
Serial_Link-SGPIO
Pin Definitions
Pin# Definition Pin Definition
1 NC 2 NC
3 Ground 4 Data Out
5 Load 6 Ground
7 Clock 8 NC
Serial Link General Purpose I/O
Headers
Two Serial-Link General Purpose
Input/Output (S-SGPIO1 and
S-SGPIO2) headers are supported
on the motherboard. These headers
are used to communicate with the
enclosure management chip in the
system.
NC = No Connection