Supermicro SuperServer 5013C-M8, User Manual

Page: 76 / 94

7-8
S
UPER
S
ERVER 5013C-M8 User's Manual
UART Mode Select
This setting allows the user to select the UART mode for the BIOS. The options
are "IrDA", "ASKIR" and " Normal ".
RxD, TxD Active
This allows the user to change the settings for the "RxD, TxD Active" function.
The options are "Hi, Hi", " Hi, Lo ", "Lo, Hi" and "Lo, Lo".
IR Transmission Delay
If "Enabled", the transmission of IR (infrared) signals will be delayed. The options
are " Enabled " and "Disabled".
UR2 Duplex Mode
This setting sets the UR2 Duplex Mode. The options are "Full" and " Half ".
Use IR Pins
This item sets the usage of the IR pins. The options are "RxD2, TxD2" and " IR-
Rx2Tx2 ".
Onboard Parallel Port
This setting allows the user to set the address and the corresponding IRQ for the
onboard parallel port. The options are "Disabled", " 378/IRQ7 ", "278/IRQ5" and
"3BC/IRQ7".
Parallel Port Mode
This setting sets the mode for the onboard Parallel port. The options are " SPP ,"
"EPP", "ECP" "ECP+EPP" and "Normal".
EPP Mode Select
This setting allows the user to select the EPP port type. The options are "EPP
1.9" and " EPP 1.7 ".
ECP Mode Use DMA
This setting allows the user to select the DMA channel for the ECP mode (port)
to use. The options are "1" and " 3 ".
Watch Dog Timer Select
This setting allows you to select the setting for the Watch Dog Timer. The
options are " Disabled ", "10 Sec", "20 Sec", "30 Sec", "40 Sec", "1 min", "2 min"
and "4 min".