Supermicro SUPERSERVER 2028TP-HC0R-SIOM, User Manual

Page: 45 / 80

Chapter 6: Advanced Chassis Setup
6-3 6-2
SUPERSERVER 2028TP-HTR/HC0R/HC1R-SIOM USER'S MANUAL
6-2 Control Panel
The control panel is located on the front of the chassis. The LEDs inform you of
system status.
See Chapter 3 for details on the LEDs and the control panel buttons.
Figure 6-1. Front and Rear Chassis Views
6-3 Chassis Cover
Before operating the chassis for the first time, it is important to remove
the protective film covering the top of the chassis, in order to allow for proper
ventilation and cooling.
Removing the Chassis Cover and Protective Film (Figure 6-2)
1. Uplug the AC power cord from any external power source.
2. Remove the two screws which secure the top cover onto the chassis as
shown above.
3. Lift the top cover up and off the chassis.
4.
Peel off the protective film covering the top cover and the top of the chassis
5. Check that all ventilation openings on the top cover and the top of the chassis
are clear and unobstructed.
6. Replace the chassis cover and reconnect the AC power cord.
Figure 6-2. Removing the Chassis Cover
Caution: Except for short periods of time, do NOT operate the server without the
cover in place. The chassis cover must be in place to allow proper airflow and prevent
overheating.
SATA Drives (24)
Control Panel
Control Panel
Control Panel
Control Panel
Note: the figure above shows a server with AOC-MTG-i4S SIOM cards installed.
See Figure 6-18 for a map of the hard drives.
Remove two
screws
Check Ventilation
Openings
1
4
1
5
1
2
1
3
Power Supplies
USB Ports UID Switch/LED VGA Port
LAN Ports IPMI LAN Port Low-Profile PCI-E Slot