Supermicro SUPERSERVER 1028R-TDW, User Manual

Page: 49 / 76

WIT.RU
WIT Company – поставка серверов, СХД,
сетевого оборудования, лицензионного ПО
Chapter 6: Advanced Chassis Setup
6-7 6-6
SUPERSERVER 1028R-TDW USER'S MANUAL
Figure 6-4. Removing a Hard Drive
1
1
1
2
DVD Drive Installation
The SC113TQ chassis can install an optional DVD-ROM.
Installing or Replacing a DVD-ROM Drive (Figure 6-5)
1. Power down the system and if necessary, remove the server from the rack
and the front bezel from the chassis.
2. Remove the chassis cover.
3. Unplug the drives power and data cables from the serverboard and/or
backplane.
4. If you are adding a new drive: Remove the mini-bezel (grate) from the drive
bay The bezel can be removed by pulling out the hard drive beneath the
DVD-ROM, then pulling the mini-bezel forward.
If you are replacing a drive: Locate the locking tab at the rear (left hand side
when viewed from the front) of the DVD-ROM drive. Push the tab toward the
drive and push the drive unit out the front of the chassis.
5. Insert the new drive unit in the slot until the tab locks in place.
6. Reconnect the data and power cables.
7. Replace the chassis cover (replace the server in the rack, if necessary) and
power up the system.
Figure 6-5. Installing the DVD-ROM Drive
Drive
Screw
Drive
Screws
Mini Bezel
Lock Screw
Caution: Use caution when working around the hard drive backplane. Do not touch the
backplane with any metal objects and make sure no ribbon cables touch the backplane
or obstruct the holes, which aid in proper airflow.
Caution: Regardless of how many hard drives are installed, all drive carriers must
remain in the drive bays to maintain proper airflow.
Warning: Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the Supermicro
website at
http://www.supermicro.com/products/nfo/files/storage/SAS-CompList.pdf