SuperServer 5019P-WT/WTR User's Manual
37
36
Chapter 3: Maintenance and Component Installation
Figure 3-1. Removing the Riser Bracket
Figure 3-2. Installing Expansion Cards
PCI Expansion Card Installation
The system includes two pre-installed riser cards (p/n CSE-RR1U-E8 and RSC-R1UW-2E16)
that positions standard size PCI-E cards at a 90 degree angle, allowing them to fit inside the
chassis.
Installing PCI Expansion Cards
The riser cards are already pre-installed into the motherboard. Perform the following steps
to install an add-on card if needed:
1. Remove the riser card bracket from the chassis by unscrewing only those screws
indicated by the screwdriver icon as illustrated in Figure 3-1.
2. Lift the riser card bracket from the chassis.
3. Install the riser card on the bracket using the two screws provided.
4. Open the latch on the end of the bracket.
5. Install the expansion card by sliding the card into the appropriate slot in the riser card,
and then close the bracket latch over the end of it.
6. Install the entire assembly into the appropriate slot on the serverboard while aligning the
bracket in the rear of the chassis.
Note:
The figures above are intended to show the PCI-E expansion card installation locations
only. The serverboard may differ from that found in the 5019P-WT/WTR.
