2-10
S
UPER
S
ERVER 1015B-M3 Manual
2-5 Checking the Serverboard Setup
After you install the server in the rack, you will need to open the unit to make sure
the serverboard is properly installed and all the connections have been made.
Removing the Chassis Cover (Figure 2-7)
Grasp the two handles on either side and pull the unit straight out until it
1.
locks (you will hear a "click").
Remove the screws securing the top cover to the chssis.
2.
Slide the cover toward the rear of the chassis.
3.
Lift the cover off the chassis.
4.
Checking the Components
You should have one or two processors already installed into the serverboard.
1.
Each processor needs its own heatsink. See Chapter 5 for instructions on
processor and heatsink installation.
Figure 2-7: Removing the Chassis Cover
4
3
Summary of Contents for SUPERSERVER 1015B-M3
