Supermicro Supero SUPERSERVER 5086B-TRF, User Manual

Page: 52 / 106

5-18
S
UPER
S
ERVER 5086B-TRF User's Manual
Watch Dog Enable/Disable
Jumper JWD controls the Watch Dog
function. Watch Dog is a system moni-
tor that can reboot the system when a
software application hangs. Jumping
pins 1-2 will cause WD to reset the sys-
tem if an application hangs. Jumping
pins 2-3 will generate a non-maskable
interrupt signal for the application that
hangs. See the table on the right for
jumper settings. Watch Dog must also
be enabled in BIOS.
Note: When enabled, the user needs
to write their own application software
in order to disable the Watch Dog
Timer.
Watch Dog
Jumper Settings
Jumper Setting De fi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 to
enable or disable the LAN1 and LAN2
Ethernets ports. See the table on the
right for jumper settings. The default
setting is enabled.
LAN1/2 Enable/Disable
Jumper Settings (JPL1)
Jumper Setting De fi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
BMC Enable
Jumper JPB1 allows you to enable the
embedded BMC (Baseboard Manage-
ment) controller to provide IPMI 2.O/
KVM support on the serverboard. See
the table on the right for jumper set-
tings.
BMC Enable
Jumper Settings
Jumper Setting De fi nition
Pins 1-2 BMC Enable
Pins 2-3 Normal (Default)
BMC Reset
Use Jumper JPRST1 to reset the BMC
settings on the serverboard. See the
table on the right for jumper settings.
BMC Reset
Jumper Settings
Jumper Setting De fi nition
Closed BMC Reset
Closed Normal (Default)