Supermicro SUPERO SuperServer 1018L-MP, User Manual

Page: 88 / 104

7-18
SUPERSERVER 1018L-MP User's Manual
Port 0 ~ Port 3 Hot Plug
This feature designates this port for hot plugging. Set this item to Enabled for
hot-plugging support, which will allow the user to replace a SATA drive without
shutting down the system. The options are
Enabled and Disabled.
Port 0 ~ Port 1 SATA Device Type
This feature configures the selected SATA port to support either a solid state
drive or hard disk drive. Set this item to Enabled to enable hot-plugging. The
options are
Hard Disk Drive and Solid Sate Drive.
Port 0 ~ Port 3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a
COMRESET initialization sequence to the device. The options are Enabled and
Disabled .

PCIe/PCI/PnP Configuration
This feature allows the user to set the PCI/PnP configurations for the following items:
Above 4G Decoding
Select Enabled for 64-bit devices to be decoded above the 4GB address space
If 64bit PCI decoding is supported by the system. The options are
Disabled and
Enabled.
VGA Palette Snoop
Select Enabled to support VGA palette register snooping which will allow the
PCI cards that do not contain their own VGA color palette to examine the video
cards palette and mimic it for proper color display. The options are
Disabled and
Enabled.
SLOT1 PCI-E 2.0 X16 OPROM (X10SLV only)
SLOT1 PCI-E 3.0 X16 OPROM
(X10SLV-Q only)
Select Disabled to deactivate the selected slot, Legacy to activate the slot in legacy
mode and EFI to activate the slot in EFI mode. The options are Disabled,
Legacy
and EFI.
Launch Storage OPROM Policy
This feature controls how the system executes UEFI (Unified Extensible Firmware
Interface), and legacy storage OPROM. Select Legacy Only to boot the system using
a legacy device installed in a PCI slot. The options are UEFI Only and
Legacy Only .