31
Chapter 3: Maintenance and Component Installation
CMOS Clear
JBT1 is used to clear CMOS and will also clear any passwords. This consists of two contact
pads located near the BIOS chip.
Clearing CMOS
1. First power down the blade and remove it from the enclosure.
2.
Short the CMOS pads with a metal object such as a small screwdriver.
3. Replace the cover, install the blade back into the enclosure and power it on.
Jumper Settings
The following jumper settings can be used for the SBI-6119R-T3N blade modules:
Jumper Settings
Jumper Default Setting Notes
JWD1
Pins 1-2
Pins 1-2: Time to reset (Default); Pins 2-3: Timeout to NMI
JPME1/2
Pins 1-2
Pins 1-2: ME normal operation (Default); Pins 2-3: ME Recovery Mode
JVRM1/2
Pins 1-2
Normal Operation (Default)
