Supermicro SBI-7126T-S6, User Manual

Page: 54 / 74

SBI-7126T-S6 Blade Module User’s Manual
6-14
Notes
Table 6-12. MPS Configuration Sub-menu
Menu Option Description
MPS Revision
This option allows you to select the MPS revision used for your system. Options
include 1.1 and
1.4 .
Table 6-13. PCI Express Configuration Sub-menu
Menu Option Description
Active State
Power-Management This option allows you to enable/disable PCI Express L0s and L1 link power in
your system. Options include
Enabled and D
ISABLED
.
Table 6-14. SMBIOS Configuration Sub-menu
Menu Option Description
SMI Support
This option enables SMBIOS SMI Wrapper support for Plug-and-Play Func
50h-54h. Options include
Enabled and D
ISABLED
.
Table 6-15. Remote Access Configuration Sub-menu
Menu Option Description
Remote Access
This option allows you to select your remote access type. Options include COM1
and
COM2 .
Serial Port Number
This option allows you to select a serial port for console redirection if the
selected port is enabled. Options include COM1 and
COM2 .
The Base Address IRQ is displayed statically under this option for your
reference.
Serial Port Mode
Use this option to select the serial port mode setting. Options include 115200
8,n,1 / 57600 8,n,1 / 38400 8,n,1 / 19200 8,n,1 / 09600 8,n,1
Flow Control
This option allows you to select Flow Control for redirection. Options include
None , H
ARDWARE
or S
OFTWARE
.
Redirection After
BIOS POST
This option allows you to specify redirection after BIOS POST. Options include
the following:
• D
ISABLE
– Turns off the redirection after POST
• B
OOT
L
OADER
– Redirection is active during Boot Loader
• Always – Redirection is always active.
NOTE: Some operating systems may not work if set to Always .
Terminal Type
This option allows you to select the Terminal Type for your system. Options
include
ANSI , VT100 and VT-UTF8.
VT-UTF8 Combo Key
Support Use this option to enable VT-UTF8 Combination Key support for ANSI/VT100
terminals. Options include
Enabled and D
ISABLED
.
Sredir Memory
Display Delay This option gives the delay in seconds to display memory information. Options
include No
Delay , D
ELAY IN
1 S
EC
, D
ELAY IN
2 S
EC
and D
ELAY IN
4 S
EC
.