21
Chapter 3 E100-9APP I/O Introduction
Chapter 3
E100-9APP I/O Introduction
This section describes the E100-9AP I/O connectors
and pin definition. Please review the
Safety Precautions in Appendix A before installing or removing components. Illustrations
showing front and rear I/O layouts and a motherboard layout indicating component locations
and I/O port locations may be found in Chapter 1.
Please review the Safety Precautions in Appendix A before installing or removing components.
3.1 Front I/O
LAN Ports
Two LAN ports (LAN1 ~ LAN2) are located on the I/O back panel. These ports accept RJ45
type cables. Please refer to the LED Indicator section for LAN LED information. See the table
below for pin defintions.
Back Panel USB 3.0
Pin Definitions
Pin#
Definition
Pin#
Definition
1
VBUS
10
VBUS
2
D1-N
11
D2-N
3
D1-P
12
D2-P
4
GND
13
GND
5
Stda_SSRX1-N
14
Stda_SSRX2-N
6
Stda_SSRX1-P
15
Stda_SSRX2-P
7
GND_DRAIN
16
GND_DRAIN
8
Stda_SSTX1-N
17
Stda_SSTX2-N
9
Stda_SSTX1-P
18
Stda_SSTX2-P
Universal Serial Bus (USB) Ports
There are two USB 3.0 ports (USB4/5) and one USB 3.1 Type-C port (USB6) on the front
I/O panel. They give complete Plug & Play and hot swapping capability. The USB interface
is compliant with USB UHCI, Rev. 3.0. The USB interface supports Plug and Play, which
enables you to connect or disconnect a device without turning off the system.
HDMI Port
The HDMI (High-Definition Multimedia Interface) port is used to display both high definition
video and digital sound through an HDMI-capable display, using the same (HDMI) cable.
VGA Port
The onboard VGA port is located next to HDMI port on the front I/O panel. Use this connection
for VGA display.
