Supermicro 7048R-C1R, User Manual

Page: 13 / 79

Chapter 2: Server Installation
2-7 2-6
S
UPER
S
ERVER 7048R-C1RT/7048R-C1R User's Manual
Figure 2-4. Installing the Server into a Rack
Installing the Server into the Rack
You should now have rails attached to both the chassis and the rack unit. The next
step is to install the server into the rack. You should have two brackets in the rack
mount kit. Install these first keeping in mind that they are left/right specific (marked
with "L" and "R"). Then, line up the rear of the chassis rails with the front of the rack
rails. Slide the chassis rails into the rack rails, keeping the pressure even on both
sides (you may have to depress the locking tabs when inserting).
When the server has been pushed completely into the rack, you should hear the
locking tabs "click". Finish by inserting and tightening the thumbscrews that hold
the front of the server to the rack (see Figure 2-4).
Installing the Rack Rails
Determine where you want to place the SuperServer 7048R-C1RT/7048R-C1R
in the rack. (See Rack and Server Precautions in Section 2-3.) Position the fixed
rack rail/sliding rail guide assemblies at the desired location in the rack, keeping
the sliding rail guide facing the inside of the rack. Screw the assembly securely to
the rack using the brackets provided. Attach the other assembly to the other side
of the rack, making sure both are at the exact same height and with the rail guides
facing inward.
Figure 2-3. Installing the Rails to the Chassis
Warning: Do not pick up the server with the front handles. They are de-
signed to pull the system from a rack only.
Warning: Stability hazard. The rack stabilizing mechanism must be in
place, or the rack must be bolted to the floor before you slide the unit out
for servicing. Failure to stabilize the rack can cause the rack to tip over.
Note: Figure is for illustrative purposes only. Always install servers to the bottom
of a rack first.
Warning: Slide rail mounted equipment is not to be used as a shelf or a
work space.