Supermicro 5015M-T, User Manual

Page: 43 / 118

Chapter 5: Advanced Motherboard Setup
5-9
To Install: Insert module vertically and press down until it snaps into place. Pay attention to the bottom
notches.
To Remove: Use your thumbs to gently push each release tab outward to free the DIMM from the
slot.
Figure 5-4. DIMM Installation
Note: Notch
should align
with its
receptive point
on the slot
Notch
Notch
Release
Tab
Release
Tab
5-7 Adding PCI Add-On Cards
The 5015M-T/5015M-T+ can accommodate either one PCI-X 133 MHz (full length)
card or (with the optional CSE-RR1U-ELi riser card) one PCI-Express x8 card.
To install an add-on card, begin by removing the PCI slot shield for the slot you
wish to populate. Fully seat the card into the correct riser card slot, pushing down
with your thumbs evenly on both sides of the card. Finish by using a screw to
secure the top of the card shield to the riser card. The PCI slot shields protect the
motherboard and its components from EMI and aid in proper ventilation, so make
sure there is always a shield covering each unused slot.