Superlift RDO1 C, Instruction Manual

Page: 3 / 15

- 3 -
RDO1 C
FEATURES
Your Automatic Roller Door Opener has many features which you will appreciate. The components and materials
used in this Automatic Opener are of the latest technology and highest quality. Below are listed a few of the
many features.
OPERATION
To operate the door simply press the hand held transmitter, wall mounted transmitter or optional wall switch for
two seconds and the door will automatically open or close. The door can be stopped during an opening or closing
cycle by pressing again. The next actuation will move the door in the opposite direction.
HOPPING CODE.
Every time a transmission is made from the Remote Transmitter a new security code is generated. The number of
possible code combinations is over 4.29 billion.
INTELLIGENT SAFETY OBSTRUCTION SYSTEM.
If the door encounters an obstruction during the Closing Cycle it will automatically reverse. The amount of force
the door should encounter before reversing, is user adjustable and should be determined, during the initial
installation of the automatic door opener. If the door encounters an obstruction during the Opening Cycle it will
stop. The Safety Obstruction Force should be checked at least once a month. (Refer to installation manual for
further instructions.)
SECURITY CODE STORE
The opener uses state of the art technology in storing your selected Transmitter Security Code. Up to 6 different
codes can be stored . To store any code simply press and hold the Door Code button on the Opener and press the
Transmitter button twice. Each or all codes can be deleted and changed at any time. (Refer to installation manual
for further instructions)
AUTO COURTESY LIGHT
A Courtesy Light on the Opener is activated automatically wherever the door commences an opening or closing
cycle. The light will stay on for approximately three minutes.
PHOTO ELECTRIC BEAM (OPTIONAL)
The Opener has an input for a Photo Electric Beam to be connected for additional safety protection and for use in
conjunction with the Auto Close Mode.
SAFETY AUTO RUN TIME
If the Opener does not complete its cycle within 30 seconds the Opener will - stop if on the Opening Cycle, or
reverse back to the fully open position if on the Closing Cycle.
MANUAL OPERATION
The Opener is equipped with a Manual Disengaging Device. If the power supply is disrupted the door can be put
into Manual Mode by pulling down once on the release cord/ handle and releasing. This will allow you to
manually open or close the door. When power is restored the Opener can be re-engaged by pulling down once
more on the release cord/lever.