APPLIANCE ASSEMBLY
• First put the
container (6)
over the drive
connection (7)
onto the
motor unit (9)
.
• Turn the
container (6)
clockwise until it locks into
place and cannot be removed anymore from the
motor unit (9)
.
• Then put the
lower pulp strainer (5)
onto the
container (6)
with the handle of the
pulp strainer (5)
resting in the designated notch of the container’s
handle.
• Then put the
upper pulp strainer (4)
onto the
lower
pulp strainer (5)
with the handle of the
upper pulp
strainer (4)
enclosing the handle of the
lower pulp
strainer (5)
.
• Next put the
small juicer cone (3)
onto the
drive
connection (7)
. The clamp of the
small juicer cone (3)
must click into place and in doing so, connect both
pulp strainers (4 + 5)
.
• Depending on the size of the fruits, you will have
to place the
large juicer cone (2)
onto the
small
juicer cone (3)
. Make sure that the openings in the
bottom frame of the
large juicer cone (2)
run over
the blades of the
small juicer cone (3)
.
OPERATING THE APPLIANCE
NOTE: Only use the appliance for squeezing citrus fruits (oranges, lemons,
limes, grapefruits)!
TIP: The lid can be used as bowl. For this, turn the lid upside down and
have it sit on the handle which will then function as the leg.
After having assembled the appliance according to above steps, you can start
juicing fruits.
1.
Cut the desired citrus fruits into halves without peeling them!
2.
Choose the
juicer cone (2, 3)
according to the fruits (oranges and
grapefruits usually require the
large juicer cone (2)
. For lemons and limes
use the
small juicer cone (3)
).
3.
Fully unwind the mains cable and connect it to a properly installed wall socket.
104570_A6_GB_121228.indb 6
28/12/12 10:48 AM