Superiorfireplaces.US.com
126718-01_D
30
FIREPLACE INSTALLATION
Continued
UPGRADING DRL4543 TO INDOOR/OUTDOOR SEE-THRU
APPLICATION
WARNING: LDSTI must be installed before install-
ing LDSTO.
Installing Exterior Door
1. Center and level exterior door on rear face of the see-thru fireplace.
Exact dimensions for the location of the door are shown in Figure
44.
2. Using self tapping screws (provided) secure exterior door to the
face of the fireplace by drilling through holes on door into the
fireplace face (Figure 45). You may chose to drill pilot holes into
the face using a 1/8" drill bit. Do not use self tapping screws, use
any #10 x 1/2" screw.
3. In locations of extreme weather, it is recommended to apply a bead
of high temperature sealant around the edge where the exterior
door meets the fireplace face.
NOTE:
When finishing the face of the exterior side of the fireplace,
use only non-combustible materials. You may extend up to the edge
of the exterior door covering up the screws used for installation.
Installing Outdoor Barrier F2253.
1. Using a flat head screwdriver, pop out the top and bottom trim
pieces an shown in figure 46.
2. Remove the outside screws on both top and bottom but leaving
two middle screws (top and bottom) in place.
3. Secure outdoor barrier using the four screws previously removed.
4. Secure top and bottom trims back in place.
Removing Exterior Glass Door
1. Using a flat head screw driver, pop out the top and bottom trim
pieces as shown in Figure 46.
2. Remove 8 screws at top and bottom of glass door and remove
glass door.
11
5
/
8
"
(295 mm)
11
5
/
8
"
(295 mm)
11
5
/
8
"
(295 mm)
11
5
/
8
"
(295 mm)
1
1
/
4
"
(32 mm)
3" (76 mm)
1
5
/
8
" (41 mm)
3
1
/
2
" (89 mm)
10
1
/
2
"
(267 mm)
10
1
/
2
"
(267 mm)
Figure 44 - Installing Exterior Door for See-Thru In/Out Application
Figure 45 - Installing Exterior Door for See-Thru In/Out
Application
Fireplace
Face
Exterior Door
Outside
Screws
Middle Screws
Top Trim
Bottom
Trim
Figure 46 - Removing Exterior Glass Door for Cleaning
