Superiorfireplaces.US.com
126741-01C
16
FIREPLACE INSTALLATION
Continued
INSTALLING LOGS AND GLOWING EMBERS
A 4 piece ceramic log set comes packed inside the unit firebox.
Removal of glass door is necessary to unpack and assemble logs
and add hearth treatments. Follow steps under Removing/Replacing
Glass Door, page 15 to access logs and burner.
Assemble logs and add burner treatments as follows:
1. Position base log onto burner log mounts (see Figure 28).
Note:
Cut out on bottom should fit over mounts and base log
should be positioned against rear panel.
2. Position holes on bottom of rear log over pins on base log (see
Figure 28).
3. Position top left log and top right log onto rear log and base
log as shown in Figure 28.
Figure 27 - Removing/Replacing Glass Door
Spring Clips
Glass Panel
Frame Rail
1. Lift Up Panel
at Lower Rail
Figure 26 - Removing/Replacing Glass Door
Locating
Hole
Door Pin
Glass Panel
Frame Rail
2. Swing Out
Panel
3. Lower
Panel Out
4. Break ember material into quarter sized pieces and place a single
layer along the full length of ember tray to hide bottom edge of
base log (see Figure 29).
5. Replace glass door and louver panels (see Removing/Replacing
Glass Door, page 15).
WARNING: The glass door must be securely in
place before running this fireplace. Do not run this
fireplace if glass is missing or broken.
Figure 28 - Installing Logs
Figure 29 - Applying Ember Material
Top
Right
Log
Top Left
Log
Rear
Log
Burner
Base Log
Rear Log
Stand
Burner Pan
Log
Mounts
Ember
Tray
Ember
Material
