8
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
WARNING: DO NOT REMOVE THE AC-
TUATOR ARM LOCKING SCREW UNLESS
THE COMPLETE OUTSIDE AIR VENT SYS-
TEM HAS BEEN INSTALLED IN ACCOR-
DANCE WITH THE DETAILED INSTRUC-
TIONS PROVIDED WITH THE KIT.
Figure 15
Note: Supply wires may be alternatively connected to the outlet using the screw terminals,
however the black supply wire must be wired to a terminal that is opposite (across the outlet) the
point where the white supply wire is connected.
Figure 16
Figure 17
Locate the actuator arm along the right side of
the appliance firebox opening and refer to
Fig-
ure 17. After completing the installation of the
Outside Combustion Air Kit remove and discard
the actuator arm locking screw.
To operate, push the end of the actuator to the
left as shown in
Figure 17, until it "pops" free
of its "locked" position. Pull the actuator for-
ward to open the combustion air door, and
push it back to close. To "lock" the combustion
air door closed, ensure the actuator is pushed
all the way back then push the end of the
actuators to the right until the step in the
actuator moves behind the appliance front
face within the slotted opening.
Operate the actuator through several cycles
including the "lock" position. Ensuring proper
operation and freedom of movement. Return
the actuator arm to the locked position.
Step 8. Installing Logs and Rockwool – The
logs are packaged and boxed within the firebox.
The bag of rockwool is in the lower control
compartment. Remove the rockwool from the
packaging and tear into quarter size pieces (see
Homeowners Care and Operation Instructions).
Spread along the front edge of the front burner.
Do not use more than is necessary.
White
(Supply)
Black
(Supply)
Bipolar
Terminal
Screw
120 Vac
60 Hz
Ground Wire
Connection
Remove Locking Screw
and “Pop” Actuator to the
Left Before Initial Use
Combustion Air
Actuator
Pull Forward to Open,
Push Back to Close
³₈
" Nipple
Gas Stub
¹₂
" x
³₈
" Flare
Shut-Off Valve
³₈
" Flex Tubing
³₈
" NPT Flare Fitting
(Remove Before
Hard Piping)
³₈
" Union
³₈
" Close Nipple
³₈
" Shut-Off Valve
¹₂
" x
³₈
" Reducer
Gas Valve
(Millivolt or
Electronic)
Gas Flex Line (provided)
Alternate “Hard Piping”
(may be required in some areas, consult local codes.)
Note:
¹₂
" NPT At Inlet Of Gas Valve For Electronic Models.
