Superior Signal Company LLC AccuTrak
®
VPE
User’s Manual
© 2015
13
BATTERY INSTALLATION
There is a sliding battery door located on the back of the AccuTrak
®
VPE. To
install or change the battery, please follow these instructions:
Turn the unit over so that the controls
are facing the floor, and the sensor is
facing away from your body.
At the opposite end from the
sensor nose (the end closest
to you) there is a sliding panel.
Apply minimal pressure to the center
of the panel and slide it towards you,
exposing the battery compartment.
Install a new 9 volt alkaline battery, noting the (+) and (-) positions which
are indicated on the inner label.
When a good battery is properly installed & accepted the display will blink.
The Serial Number of your AccuTrak
®
VPE is printed on a label located
inside the battery compartment.
CARE & MAINTENANCE
The AccuTrak
®
VPE can be cleaned with a towel using dish soap and damp
cloth. Remove the battery and close the door before cleaning. Do not allow
water to enter the unit, especially the front where the sensor is located. After
cleaning, dry the unit with a paper towel. Any automotive vinyl cleaner (on a
piece of cloth) will restore the luster. The same procedure can be used on the
carrying case. If you plan to store the instrument for an extended period of
time, remove the battery.
Calibration
Superior AccuTrak
®
instruments are designed in a way to minimize the need
for regular calibrations. They are constructed with components of very tight
tolerances, and do not age rapidly. If there is a need to know for sure that the
instrument is consistent with manufacturer specifications, or if you suspect a
problem, we will perform the calibration at a fixed cost. Call the factory for
instructions and current calibration costs.
For service & repairs contact:
SUPERIOR SIGNAL COMPANY LLC
Phone: (732) 251-0800
●
Fax: (732) 251-9442
