www.SuperiorFireplaces.US.com
126861-01A
18
+
+
-
+
-
-
AAA
AAA
AAA
Figure 26 - Battery Install Hand-Held
Remote Control
Battery Housing
Cover
Figure 25 - Remote Display
Installing Hood
1. If required, install hood as shown on page
16.
INSTALLING BATTERIES IN
REMOTE CONTROL AND RECEIVER
WARNING: Make sure your
selector switch is in OFF posi-
tion before installing or chang-
ing batteries in your hand-held
remote or receiver.
Installing Battery into Remote
1. Remove battery housing cover from back
of hand-held remote (See Figure 25).
2. Install 3 AAA batteries.
3. Replace battery housing cover.
When batteries are installed, the "little house"
icon with current room temperature will be dis-
played (see Figure 25). This icon will always
show in the control window as long as the
batteries have power.
Figure 24 - Access Door for See-Thru
Applications
Access
Door
Flange on
Face Bottom
Side
Filler
Retaining
Bracket
INSTALLATION
Continued
Installing Access Door
1. Place access door into retangular opening
in front of the glass door with the slanted
side facing forward. The slanted surface
will slide underneath the flange of the
bottom face Insert tabs on side of access
door into slots on retaining brackets (See
Figure 24).
Locating Remote Receiver
1. Remove Access Plate (See Figure 24).
2. Remove 2 screws on top of the electronic
access cover (See Figure 27).
3. Remove electronic access cover by gently
pulling up and out of the fireplace. There
are two switches connected to cover.
4. The remote receiver is located on the right
as shown in Figure 28, page 19.
Figure 27 - Removing Control Access
Cover (Face Bottom not shown for
Clarity)
Remove
Screws
Electronic
Access
Cover
