SuperiorFireplaces.us.com
900719-00B
9
Figure 5 - Installing Hood
Screw
Hood
Rail
INSTALLATION
Continued
Figure 6 - Assembling Perimeter Trim
Assembled
Trim
Figure 7 - Attaching Perimeter Trim to
Fireplace
Trim
Hanging
Screws
Hanging
Notches
on Trim
Side Trim
Slot
Mitered
Edge
Slot
Shim
Set Screws
Adjusting
Plate
Top
Trim
Mitered
Edge
ASSEMBLING AND ATTACHING
OPTIONAL PERIMETER TRIM
(Included with Mantel Accessory)
IMPORTANT:
If you are recessing the
fi
rebox
in a wall, do not attach trim at this time. See
Built-In Fireplace Installation
,
Page 11
.
NOTE: These instructions show assembling
and attaching trim to fi replace.
1. Remove packaging from three pieces
of trim.
CHECK GAS TYPE
Use the correct type of gas (natural or propane/
LP). If your gas supply is not the correct gas
type, do not install appliance. Call dealer
where you purchased the appliance for proper
type appliance.
WARNING: This appliance is
equipped for natural or propane/
LP gas but not both. Gas type is
indicated on rating plate. Field
conversion is not permitted.
ELECTRICAL HOOKUP
This
fi
replace includes a blower which must
be connected to either a wall receptacle or
the electrical receptacle that is included within
the
fi
replace. If the receptacle included with
the
fi
replace is to be used, it must be wired
to a 120 volt supply by a certi
fi
ed electrician.
INSTALLING HOOD
Install hood to rail already installed in
fi
replace
as shown in
Figure 5
. Use 3 Phillips screws
provided.
2. Locate four screws, two adjusting plates
with set screws, and two shims in the
hardware packet.
3. Align shim under adjusting plate as shown
in
Figure 6
.
4. Slide one end of adjusting plate/shim
in slot on mitered edge of top trim
(see
Figure 6)
.
5. Slide other end of adjusting plate/shim
in slot on mitered edge of side trim
(see
Figure 6).
6. While firmly holding edges of trim to-
gether, tighten both set screws on the
adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other side.
8. Tighten trim hanging screws (#10 x 6.25
shoulder) into holes in cabinets. Place
the assembled trim onto
fi
replace cabi-
net. Align hanging notches on trim with
hanging screws on side of
fi
replace
(see
Figure 7).
Push trim
fi
rmly into place, slid-
ing hanging notches over hanging screws.
