NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
41
NOTE
: It is important to ensure proper log and or media placement per the
manual when installing these units. Verify pilot flame is not obstructed.
See Verifying Appliance Operation on
Page 23
.
Step 1.
Install the ceramic or porcelain panels, per the instructions
provided in kit.
Step 2.
Place volcanic stone around the burner, as shown in
Figure 53
.
Step 3.
Separate the glowing embers from the larger bag into pieces about
the size of a quarter, as shown in
Figure 54
. Mix the glowing
embers with the bag of platinum embers also provided with the
fireplace. Keep the pieces fluffed, not matted. Distribute these
pieces over the burner as shown in
Figure 55
. Do not use more
glowing embers than necessary. When properly positioned, the
glowing embers will cover approximately 75% of the burner for
natural gas applications.
NOTE: Excessive use of glowing embers may result in sooting or poor
flame. This appliance is provided with enough glowing embers for
several applications. Do not use all provided, in one application. For
best glowing effect, replace the ember material annually. Replacement
volcanic stone, glowing embers, and platinum embers are available
(see Table 17).
Step 4.
Position the individual logs as shown in
Figure 56
through
Figure
59
on
Page 42
. Logs should be placed in the order shown. Place
logs 2 and 3 against the pins on the grate, NOT over them.
Proper log and twig placement is critical to encourage outstanding
flame appearance and prevent sooting. When positioned properly
as shown, twigs will be positioned between flame peaks and will
not impinge any flames.
WARNING
•
DO NOT attempt to install the logs until the
appliance installation has been completed, the
gas line connected and tested for leaks and the
initial burner operation has been checked out.
•
The size and position of the log set was engi-
neered to give the appliance a safe, reliable
and attractive flame pattern. Any attempt to use
a different log set in the fireplace will void the
warranty and will result in incomplete combus-
tion, sooting, and poor flame quality.
•
Logs get very hot and will remain hot up to one
hour after gas supply is turned OFF. Handle only
when logs are cool. Turn OFF all electricity to
the appliance before you install grate, volcanic
stone, embers and logs.
•
This appliance is not designed to burn wood.
Any attempt to do so could cause irreparable
damage to the appliance and prove hazardous
to your safety.
•
If logs are not installed according to the log
installation instructions, flame impingement and
improper combustion could occur and result in soot
and/or excessive production of carbon monoxide
(CO), a colorless, odorless, toxic gas.
INSTALL VOLCANIC STONE, GLOWING EMBERS, AND LOGS
Cat. No.
Model
Description
88L53
FGE
Bag of Glowing Embers
80L42
FDVS
Bag of Volcanic Stone
H8312
PGE
Bag of Platinum Embers
Table 17 - Firebox Accessories
Figure 53 - Volcanic Stone Placement
Volcanic Stone
Figure 54 - Glowing Embers Separation
Figure 55 - Glowing Embers Placement
Glowing Embers (Rockwool)
INNOVATIVE HEARTH PRODUCTS • POWER VENT DV GAS FIREPLACES (DRT6340TYN AND DRT6345TYN) • INSTALLATION INSTRUCTIONS
f i r e - p a r t s . c o m