WN-3500 / WN-4500 / WN-5000
9
WINCH ASSEMBLY AND MOUNTING:
Winch is designed with a standard bolt pattern for its class. Different mounting kits are
available that utilize this pattern.
When installing, ensure that Mounting Plate installs to a flat surface so Motor, Winch
Drum, and Gear Housing are properly aligned. Proper alignment allows for even
distribution of full rated loads.
1. Install supplied Fairlead to supplied Mounting Plate with supplied hardware.
2. Install Winch to Mounting Plate with supplied hardware:
- Set Free Spooling Clutch to “OUT” and pull out a few inches of Synthetic Rope.
- Feed Synthetic Rope through opening in front of Mounting Plate and through Fairlead.
3. Make electrical and component connections;
See SuperATV instructions
.
4. Assemble Clevis Hook to Synthetic Rope.
- Remove Pin from Clevis Hook and connect Clevis Hook to Synthetic Rope.
- Reinstall Pin to Clevis Hook.
5. Install Stopper to Synthetic Rope.
6. Install Hand Strap to Clevis Hook.
7. Check Winch Drum for proper rotation:
- Set Free Spooling Clutch to “OUT” and pull out some Synthetic Rope.
- Set Free Spooling Clutch to “IN” and press “OUT” button on Rocker Switch. If properly
installed, Winch Drum should be turning and
releasing
Synthetic Rope. If Winch Drum
is turning and
collecting
more Synthetic Rope, reverse leads on Motor. Repeat and
check rotation.
- Remove all jewelry and wear eye protection when making battery
connections. Batteries contain flammable and explosive gases.
Avoid leaning over battery.
CAUTION
Universal Mounting Plate is supplied. Machine specific
Mounting Plates are available at www.SuperATV.com
Clevis Hook
Pin
Stopper half
Synthetic Rope
Stopper half
M6 x 35mm
M6 Washer
M6 Nut
(4) each
Hand Strap
Summary of Contents for WN-3500
Page 15: ......
