Super Systems eFlo 2.0, Operation Manual, Page: 18 / 39

eFlo 2.0 Electronic Flow Meter Operations Manual
Super Systems Inc. Page 18 of 39
P4.00
: Serial Communications – Values are modifiable and are used to set the serial
communications.
 P4.10
: Baud Rate
 P4.20
: Address
 P4.30
: Parity Bits
P5.00
: Ethernet Communications – Values are modifiable and are used to set the Ethernet
Settings.
 P5.10
: DHCP – Enabling allows the unit to automatically obtain addressing.
 P5.20
: IP Octet – Used to manually set the IP address of the device.
 P5.30
: Subnet – Used to manually set the Subnet of the device.
 P5.40
: Gateway – Used to manually set the Gateway of the device.
P6.00
: Setup – Values are modifiable and changes important device options.
NOTE: These options should ONLY be changed if absolutely necessary. Please contact SSi
before making changes to these settings.
 P6.10
: Zero Tare – Resets the zero flow rate of the meter (manual mode with valve
closed only).
 P6.20
: Analog Max Flow – Sets the 4-20mA analog in and out based on desired max
flow rate allowable.
 P6.30
: Control Mode – Sets control method of the meter. Options include Flow mode,
Valve mode, Manual mode, and Ratio mode.
o
Flow mode refers to standard control based on a specific flow setpoint for use
with standard gases.
o
Valve mode refers to valve position control based on % output (commonly used
for carbon control gases).
o
Manual mode is used for analog flow meters and in-line meters, which do not
contain valve motors for automatic flow control.
o
Ratio mode is used for specific applications involving ratio control like mixing
systems.
 P6.40
: Gas Type – Used to set the gas type of the meter.
NOTE: changing this value
may limit the amount of flow indicated by the info tag on the front of the meter.
 P6.50
: Max Valve Position Tare – Sets the max position the valve is capable of driving to
in valve position mode (manual mode with valve opened to desired max flow rate).
 P6.60:
Altitude Compensation – Sets the altitude for the installed location. Units are
feet above sea level.
 P6.70:
Decimal Point Override – Allows the flow to display with no, 1, or 2 decimal
points.
 P6.80:
Control Override – Allows temporary digital control of the meter assuming that
the meter set point is being controlled with an analog signal. When set to “Auto”, the
meter can be remotely controlled with a digital or analog signal. This feature is for
special uses. Contact SSi for more details about this option.
Reference
Appendix 1: Menu Option Tables for a detailed chart of parameter options