Super Circuits DMR16CD-3, User Manual

Page: 94 / 119

94
17. You will need to recheck all DVR network settings above, check with IP provider or IT
department, router settings, and make sure cables are good and connected. This could also
be due to a bad cable between the DVR and router or a bad DVR
Network Interface
Controller (NIC). Check the Ethernet cable connection on the back of the DVR and check for
a green light and that it blinks when you “ping” the DVR. If it is not blinking, this could
indicate that the DVR’s NIC is bad and call us for tech support. If green light is on, as a final
check, connect the DVR directly to the computer using an Ethernet crossover cable
(which is
available at any electronics store such as Radio Shack, or Best Buy, Circuit City, etc…)
eliminating all other cables and equipment. And repeat the pinging process.
-----------------------------------------------------------------
PC Ethernet Crossover Cable DVR
18. If you’re looking at FIG.1 and this is the case then you have demonstrated that a Local Area
Connection (LAN) has been made between the DVR and the computer. Proceed to Software
installation.
INSTALLING NETWORK SOFTWARE
Client software
Install and setup
Insert the Install CD into PC CD-ROM,
and software will automatically Install
program. Recommend Windows XP or
Windows 2000.
1. Click
Install Client software .
•
Select a Destination Folder.
•
When finished, the software will
create a shortcut on the desktop.
•
Click the shortcut to run the client
software.