SWL2820 Operator’s Manual
76
5.5.7
EVERY 2000 HOURS OF OPERATION
5.5.7.1
CHANGING THE COOLANT
Never change the coolant just after stopping the engine, since the coolant is still
warm. Let the coolant cool down until it goes under 40-45˚C.
Never loosen the coolant cap when the coolant is still hot. Warm water could spill
out violently and produce burnings.
Always loose the coolant cap slowly, in order to release the pressure inside the
coolant tank.
Proceed as follow for changing the coolant:
1)
Loosen slowly the coolant tank cap.
2)
Open the drain plug located in the bottom side of the radiator (See picture
below).
3)
Remove the drain plug located in the bottom side of the engine.
4)
Drain the coolant until it stops to flow.
5)
Put on and screw up the two drain plug again.
6)
Refill with the recommended coolant described in this manual.
7)
Start the engine and let it run at idle speed for a while.
8)
Stop the engine.
9)
Check the coolant level. If necessary refill until the level reaches the right
level.
5.5.7.2
CHECKING THE STARTER AND ALTERNATOR
5.5.8 WHEN REQUIRED
5.5.8.1 DRAINING THE FUEL TANK
Drain the fuel tank always with temperature exceeding 0˚C and before starting the
machine. If the temperature is lower than 0˚C drain the fuel tank after using the
machine, to prevent the condensate.
Proceed as follow for draining the fuel tank:
1)
Remove the fuel tank cap.
2)
Position a container under the draining valve located in the bottom side of
the chassis.
3)
Release the draining valve.
4)
Led the fuel flow totally.
5)
Close the draining valve.
6)
Refill the tank with the fuel type recommended in this manual.
Summary of Contents for SWL 2021 Series
Page 10: ...SWL2820 Operator s Manual 9 Float Tail warning Oil level Diesel Oil Oil filter...
Page 25: ...SWL2820 Operator s Manual 24 3 1 3 MACHINE DISTRIBUTION 1 7 2 3 4 5 6 8 9 10...
Page 45: ...SWL2820 Operator s Manual 44 A B C H G D E F...
Page 89: ...SWL2820 Operator s Manual 88 SWL2820 Hydraulic Diagram...
