22
Have the modem turned on (power light illuminated)
Have the Oscar 2 turned on and OUT of study mode (time flashing on display)
Step 3. Starting the data transfer
The central terminal operator will indicate when to begin the data transfer. To do this, press
and hold the Express button (
►►
) until you hear three rapid beeps or a “chirp”.
The Oscar2 will then automatically dial the central terminal data transfer line and the data
transfer will begin. During the data transfer through the modem, the Oscar 2 will display a
percentage to indicate the progress of the transfer. Meanwhile, the central terminal operator
can communicate to you the status of the data transfer over the voice line.
Step 4. Completing communication with Central Terminal
When the data transfer is complete, the Oscar 2 display will indicate 100% and will
automatically turn off. The unit is now ready for the next patient study if an upload was
performed.
WARNING!
: Do not store the Oscar 2 unit without batteries, otherwise the set clock time will
be lost. You can replace with new batteries immediately prior to fitting next patient. If there
were any problems with the transfer, the central terminal operator will indicate this and a data
transfer can be repeated. After a successful transfer, the modem automatically disconnects
the data line and the voice call can also be ended.
Summary of Contents for Oscar Express Remote Site
Page 1: ...Oscar Express Remote Site User s Guide...
Page 2: ...2...