Parts liste
1
Rotor cover
8
Magnet holder
2
Bearing
9
Control panel
3
Rotor
10
Adapter
4
Motor
11
Spindle
5
Rear cover
12
O-ring
6
Support
13
Lock
7
Rubber joint ring
Setting
1.
Clean the aquarium before using the pump. Dirt on the aquarium glass panes prevents a cor-
rect installation. If the pump slips off it can damage itself or the glass walls of the aquarium
(dirt can impair the grip of the magnet/suction attachments). To avoid disruptions caused by
noise and vibrations the pump should be fixed under the water surface (see illustration 1).
2.
Remove the cable and separate the two magnets.
3.
Install the magnet at the pump by fixing the rotatable axis into (
11
) the back part (
5
) of the
wave maker with the O-rings (
12
) to the support (
6
).
4.
Immerse the pump fully in the water and put it one the position you with it to have. Press the
two magnets against your aquarium glass to hold the wave maker in place. Place the external
magnet against the glass but not directly against or near the wave maker unit inside the tank.
5.
Then slide the external magnet across the glass wall till it meets the internal magnet (see illus -
tration 2).
6.
Then install the control panel in the desired location. Tip: If you also want to attach the control
panel to the aquarium, it is best to use double-sided adhesive tape.
7.
Connect the pump housing to the control unit using the three-pin connector. Connect the dir-
ect current plug to the control unit. Connect the alternating current adapter to the wall socket.
Important:
The magnets are very strong and should be handled with care and caution. Do not release
or drop the external magnet at a distance against your glass or internal magnet because this could
lead to damage of your fish tank.
© by WilTec Wildanger Technik GmbH
Artikel 51656–51659
Seite 5
http://www.WilTec.de
http://www.aoyue.eu
11 2020
-1
