32
• Questions? Call or Text +1-801-658-0015
Users Guide
Picó
How to Update the Pico’s Software
The Sunstone Pico software will be updated from time to time as needed. The software can be updated directly
from the welder via Wi-Fi or the update can be downloaded to a USB storage device and plugged into the weld
-
er for updating.
Note: Software updates are made available to Sunstone Circle customers. To learn more about the Sunstone
Circle, visit www.sunstonewelders.com/circle or call 801-658-0015.
UPDATING VIA A USB STORAGE DEVICE
•
With the welder on, insert a USB drive (containing the update files) into the USB slot on the left side of
the Pico.
•
Press the Settings Button in the Navigation Bar.
•
Press the System Button.
•
At this stage, the Pico will do a quick systems check for approximately 20 seconds.
•
When the check is complete, the Pico will give a prompt to update. Press the Install Button. The welder
will begin to update.
•
Once the update is complete, the welder will display an error message, which can be ignored—don’t call
Sunstone Customer Service. Continue to the next bullet point.
•
Turn the welder off and wait 10 seconds.
•
Remove the USB drive.
•
Turn the welder on.
•
The updated software will now launch, which may take a few minutes.
•
Once the new software is launched, the following message will appear: “Firmware Upgrading.”
•
Once completed, a message will appear letting you know the process was successful. Once the
success message appear, close the box and reset the welder.
UPDATING OVER WI-FI
•
Press the Settings Button in the Navigation Bar
•
Press System Button.
•
Tap the Update Over Wi-Fi Button. If the welder is not connected to a network, a popup message will
appear and display all available networks. Choose the network to which you wish to connect. If you do
not see your network or your network is hidden, you can press the Other Network Button to manually
type in your network SSID. Enter your password to login to your network and press Okay.
•
If the welder is already using the most updated software, a popup will appear stating that “There are no
new files to download. You are already up-to-date”. If that’s the case, you can discontinue the update
process. If the welder’s software is not the most current version, a popup with a progress bar will
appear and display the status of the download.
Summary of Contents for PicoDC
