18
D. Installation Methods of Defensor
[ Fig. 9 ]
ⓐ
A Touch two parts and assemble the upper face and side using T bracket(2 Sets).
ⓑ
B Touch two parts and assemble the upper face and side using L bracket.
ⓒ
Make the angle between one set of assembled A and B at 90
。
. Combine them on the upper face using
ㄱ
-type bracket and
combine the side using
ㄴ
-type bracket.
ⓓ
Make the angle between the combined A/B and the other one set of A at 90
。
. Combine them on the upper face using
ㄱ
-type
bracket and combine the side using
ㄴ
-type bracket.
ⓔ
Two Cs interact the center of the combined A like figure and combine them to the upper and lower face using
ㄴ
-type
bracket. Then combine the side using
ㄴ
-type bracket.
E. Installation Methods of Defensor Safety Sensor
ⓐ
Fasten the enclosed sensor bracket in the defensor
components box on the spring nut inserted to the profile
①
T slot slightly. Then put one sensor bracket 600mm
above the floor and fix one sensor bracket 600mm from
the top.
ⓑ
Fix the safety sensor to the sensor bracket.
600mm
600mm
T-Hole
①
①
[ Fig. 10 ]
