32
①
Press Up/Down keys to select a delay number. Press
+/- keys to set a value.
②
Press ENTER to save.
4.7.6) Delay
↓
↓
•
patt : Pattern number
•
X_len(length): Basic (6~22 mm) / Extended (6~30 mm)
•
Y_hei(height): 1~3.2 mm
•
space(space) : space between two patterns (automatically adjusted
by the height (Y_hei))
•
Zigz(No. of zigzag) : 6~35
•
X_bar : No. of stitches in the straight line at the beginning (2~10)
•
BAR : Select the straight line section before zigzag
- Bar(Start from Orgin #2), Ori(Start from Origin)
- One(No. 1 at the left end from the center), No(no Bar)
•
move : offset function (-2~2mm)
space
Zigz
X
-
len
Y
-
hei
①
If the entered value is out of the range, error (ERR)
occurs.
ERR53 : Length (X_len),
ERR54 : Height (Y_hei)
ERR55 : Pitch (pit),
ERR56 : bar
ERR57 : space
②
Press the (ESC) key and enter a value again.
①
Select a pattern number using +/- keys.
②
When starting the downloaded pattern through SSP, the
screen in the right figure appears.
①
Select “READY.”
②
When “ENTER” is pressed, it launches the pattern
creation process. When “ESC” is pressed, it returns to
the previous screen.
■
In the case of creating patterns in the pattern number where SSP download occurs
