29
①
Use the Up/Down keys to select among patt, X_len,
Y_hei, Zigz, X_bar, Bar, move, block. Use +/- to set
the value.
②
When the (ENTER) key is pressed, a pattern is created.
↓
↓
•
patt : Pattern number
•
X_len(length) : Basic (6~22 mm) / Extended (6~30 mm)
•
Y_hei(height) : 1~3.2 mm
•
Zigz(No. of zigzag) : 6~35
•
X_bar : No. of stitches in the straight line at the beginning(2~10)
•
BAR : Select the straight line before zigzag
- Bar(Start from Origin #2), Ori(Start from Origin)
- One(No. 1 at the left end from the center), No(no Bar)
•
move : offset function(-2~2mm)
•
block : # of blocks
①
Select the (ENTER) key.
•
squa1 : Square pattern
•
block : Block pattern
•
X_desi : X-shape pattern
•
Twin : Twin pattern
①
When the READY key is pressed, basic patterns
appear.
■
Block pattern
block
Zigz
X
-
len
Y
-
hei
①
When the value is not within the range, error (ERR)
occurs.
- ERR53 : Length (X_len), ERR54 : Height (Y_hei)
- ERR55 : Pitch (pit),
ERR56 : bar
②
Press the (ESC) key and enter a value again.
