SunSetter Motorized PRO, Owner'S Manual And Installation Instructions

Page: 10 / 36

7
2. Mark the Mounting Line on the Wall
a. Measure up from the deck or patio floor on one side and make a mark at your desired Mounting Height
(should be at least 7’ 6”).
b. Make a second mark 8”, 9” or 11” (see Note at top of page) below the first mark. The space between
these marks must be clear of obstructions (light fixtures, etc.) along the entire length of the wall.
c. Using a chalk line or a string, snap a level line on the lower mark for the length of the Awning. The
bottom of the Wall Brackets will rest on this lower line.
Note: For ease of mounting the Awning into the Brackets, it is very important that the line will be straight
and level.
Note: When making the decision on the Mounting Height, the Awning requires :
• 8” of unobstructed area along the whole length of the Awning to fit all Brackets on your wall without a Hood .
• 9” of unobstructed area along the whole length of the Awning for Standard Wall Brackets with a Hood .
• 11” of unobstructed area along the whole length of the Awning for XL Wall Brackets with a Hood .
See Figure 2 under “ Standard Projection Wall Mount ” or “ XL Projection Wall Mount ,” whichever is appropriate
for your installation.
Figure 2 - Standard Projection
Overhang
Deck
Min. Mounting
Height 7’ 6”
8” Min.*
Unobstructed Area
Wall Brackets
*Note: 9” Min. unobstructed area needed if
mounting with a Hood.
1” for cover or 2” for hood
House
6’6”
Lowest
Clearance
Pitch
of 2’5” (29”)
(Recommended)
Mounting
Height 9’
Deck
Fabric
Projection
7’, 9’, or 10’2” Standard Projection
Figure 3 - Example of a 9’ Mounting Height Installation
1” for cover or 2” for hood
Standard Projection Wall Mount
For 7’ to 10’ 2” projection Awnings
Figure 2 - XL Projection
Overhang
Deck
Min. Mounting
Height 7’ 6”
8” Min.*
Unobstructed Area
Wall Brackets
*Note: 11” Min. unobstructed area needed if
mounting with a Hood.
1” for cover or 3” for hood
House
6’6”
Lowest
Clearance
Pitch
of 2’5” (29”)
(Recommended)
Mounting
Height 9’
Deck
Fabric
Projection
11’8” for XL Projection
1” for cover or 3” for hood
Figure 3 (XL) - Example of a 9’ Mounting Height Installation
XL Projection Wall Mount
For 11’ 8” projection Awnings