Sunrise Medical TROPHY 20, Service Manual

Page: 86 / 104

Trophy 20 86 | Service instructions 86 | Service instructions
5. Hours Driven
The amount of hours the scooter has driven more than 5% of its maximum speed in its life.
First one character of the display show: h
6. Software version
First one character of the display show: F
7. Signal Actual throttle input: Range
Actual input of the active throttle available (R)
First characters of the display show: C
The Icons on the tiller display will indicate the active throttle:
• right hand is lit: right hand side throttle is active
• left hand is lit: left hand side throttle is active
• no hand icons are lit: foot throttle is active
Foot throttle information is converted by the MC into a drive signal. This signal will be presented here. OK
8. Miles / hour reset (P)
Set speed and distance calculations to km or miles.
• Km icon on display is shown = km: km per hour
• m icon on display is shown = miles: miles per hour
Default: km
Change by pressing the DSS (I) switch
≥ 2 seconds.
9. Scooter type selection.
This re fl ects the diameter of the wheels used.
• “t30” Trophy speed algorithm (Trophy 30)
• “t20” Trophy speed algorithm (Trophy 20)
Default: “t30”
Change by pressing the DSS (I) switch
≥ 2 seconds.
10. This re fl ects if a beeping sound is enabled
• "0" no beep when driving backward
• "1" beeping when driving backward
default: "1"
Change by pressing the DSS (I) switch
≥ 2 seconds
First one character of the display show: b
Setting the options
Not all options are standard available. Some options are only available as ordered at Sunrise Medical HCM. Not activated values
will not be shown in the service menu.
11. Cruise Control enable (S)
• “0” disabled
• “1” enabled
Default: “0” = disabled
Change by pressing the DSS (I) switch
≥ 2 seconds.
First two characters of the display show: CC
12. Manual / intelligent throttle switch
• “0” off
• “1” Manual Throttle Switching (MTS)
• “2” Intelligent Throttle Switching (ITS)
• “3” ITS and MTS active
Default: “0” = off
Change by pressing the DSS (I) switch
≥ 2 seconds.
First two characters of the display show: tS