930473 Rev. B
14
E n g l i s h
I X . O p e r a t i n g I n s t r u c t i o n s – M e c h a n i c a l
IX. OPERATING INSTRUCTIONS– MECHANICAL
A. NOTES
Work Surface For Set-Up:
Use a flat surface, such as a table, to assemble, adjust and check your seating system.
This makes the steps easier and helps ensure a correct set-up.
Fasteners:
• Many of the screws and bolts on this seating system are special high-strength
(Grade 8) fasteners and may have special coatings.
• Many nuts are of the Nylock type. They have a plastic insert to help prevent loos-
ening.
• Only use screws, bolts and nuts provided by Sunrise.
a. Use of improper fasteners may cause the seating system to fail.
b. Over- or under-tightened fasteners may fail or cause damage to seating system parts.
c. If bolts or screws become loose, tighten them as soon as you can. Loose bolts or
screws can cause damage to other seating system parts causing them to fail.
d. Washers & Spacers:
• Note the position of washers and spacers before disassembly.
• To avoid damage to the frame, replace all washers and spacers when you reassem-
ble parts.
e. Torque Settings:
• A torque setting is the optimal tightening for a particular fastener. Use a torque
wrench that measures inch-pounds to secure screws, nuts and bolts on this seat-
ing system.
• NOTE–
Unless otherwise noted, use a torque setting of 120 inch-pounds for all
fasteners.
f. Persons who help a rider do one of the following tasks should review and heed the
warnings “Notice to Attendants” and all warnings in this Manual for that task.
g. The “Tips” that follow are suggestions only. Be aware that you will need to learn safe
methods best suited to the rider and to your abilities. Consult your health care pro-
fessional for instructions.
B. TOOLS YOU WILL NEED
Basic Tool Kit:
To set-up, adjust and maintain your seating system you will need the following tools:
•
7/16" socket wrench
•
1/2" box and open-end wrench
•
3/4" box and socket wrench
•
5/32" hex wrench
•
3/16" hex wrench
•
3mm hex wrench
•
Phillips screwdriver #2
•
Custom axle wrench (or a 1/2" open-end wrench)
You can obtain a multi-purpose tool kit from Sunrise, or buy the tools you need from a
hardware store.
Torque Wrench:
If you plan to adjust and maintain this seating system yourself, Sunrise recommends that
you use a torque wrench.
NOTE–
The wrench must measure inch-pounds. You can buy a torque wrench and proper sockets from a
hardware store.
Summary of Contents for Quickie Smart Seat
Page 23: ......
