26
RX/RXS
Issue 5
12
0
-3
3
6
Backrest angle adjustment
(RXS only)
The angle of the backrest (Fig. 31)
can be adjusted through increments
of 3
O
, between -3
O
to 12
O
, by using
the backrest adjusting mechanisms
(1) which are located on the upper
rear frame tubes. Loosen the screw
(2) and removing screw (3) using a
6mm Allen key (on both sides of
the chair). Rotate the backrest (4)
to the required position and replace
the screw (3) into the hole which
bears the appropriate marking in
degrees (5). Tighten both screws to
24Nm torque.
Fig. 30
1
Footplate angle adjustment
Angle adjustable footplate
To adjust the footplate angle
(Fig. 30), loosen the screws (1) with
a 4mm Allen key sufficiently to
allow the footplate to be rotated to
the required angle. When at the
required angle tighten the Allen
screws using a torque spanner to
8-10Nm torque setting.
Footplate depth adjustment
To adjust the depth of the footplate
(Fig. 30), remove the two screws
(1) and relocate the footplate to the
desired depth position through the
choice of a different set of holes (2)
Refit the screws and tighten to the
settings given above.
Fig. 31
1
2
5
Chair adjustments
3
4
2
Summary of Contents for Quickie RX
Page 1: ...Owner s Manual RX RXS...
Page 2: ...47 RX RXS Issue 5...
