29
RX/RXS
Issue 5
Fig. 36
Chair adjustments
Seat height (RXS)
Seat height can be adjusted by
moving the axle sleeve (1) vertically
(Fig. 36) in the axle plate slot (2). This
allows a 114mm adjustment in 13mm
increments. First loosen the 28mm A/F
outer retaining nut (3) sufficiently to
allow the sleeve and locating plate (4)
to slide, and position the sleeve and
plate at the required height, ensuring
that the keys (5) are located in the
required keyways (6). Tighten the
retaining nut using a torque wrench to
a setting of 45Nm.
Note:
After adjusting the axle position, the
front castors must be checked for
adjustment (see page 32, Fig. 42).
2
1
Seat height adjustment (RX)
To adjust the seat height (Fig. 37),
remove the wheel by unscrewing
the 19mm A/F retaining nut (1, if
quick-release axles are not fitted),
the wheel spacer (2, if fitted), and
the axle (3). Move the axle to the
desired position using one of the
two holes (4) in the axle plate and
replace the axle and tighten to
45Nm torque setting, replace the
wheel, spacer and retaining nut and
tighten to 45Nm.
Note:
After adjusting the axle position, the
front castors must be checked for
adjustment (see page 32, Fig. 42).
Fig. 37
4
3
4
5
6
3
2
1
Summary of Contents for Quickie RX
Page 1: ...Owner s Manual RX RXS...
Page 2: ...47 RX RXS Issue 5...
