18
Rubix2
ENGLISH
HEIGHT-ADJUSTABLE ARMRESTS
To adjust the height, pull the lever (1) and
push the armrest to the desired height.
Afterwards make sure that the lever (1)
locks back into position. Removing the
armrest is carried out in the same way.
To remove the sideguard completely, push
the lever (2). When fitting the sideguard, the lever (2) must also be
pulled.
Always make sure that the sideguard locks into position
correctly in the receiver.
(Fig. 34)
Fig.34
1
2
Options – Hemiplegic armrest
HEMIPLEGIC ARMREST
The hemiplegic armrest can be
adjusted both in length and angle.
You can adjust the length by
pushing the armrest after having
loosened the 2 rotary screws (1).
To adjust the angle, open the
release lever (2) and rotate the
armrest to the desired position,
then tighten it again (Fig. 37).
Fig.37
2
1
ANTI-TIP TUBES
Anti-tip tubes provide additional
safety for inexperienced users when
they are still learning how to operate
their wheelchair. They prevent a
wheelchair from tipping over
backwards. The anti tip
tube should
be inserted into the frame tube until
the first of the two spring buttons
enters the first hole in the frame tube,
(Fig.38).
WARNING!
Incorrect setup of the anti-tips will increase the risk of a rearwards
tip. You must swing the anti-tips upwards when going up or down
large obstacles, (such as a kerb), to prevent them from touching the
ground, then rotate them back down to the normal position.
NOTE:
Do not insert both buttons of the anti tip tube into the frame
tube as this could damage the anti Tipp and cause a loss of
effectiveness. By pushing on the Second exposed
release button,
the safety wheels can be set upwards or removed. There must
always be a gap of between 3 cm and 5 cm between the tube and
the ground. You must swing the safety wheels upwards when going
up and down large obstacles (such as a kerb) to prevent them from
touching the ground. Then rotate the safety wheels back down to
the normal position (Fig. 38).
WARNING!
Incorrect set up of the anti tips will increase the risk of a rearwards
tip.
Options – Anti-Tip Tubes
Fig.38
Fig. 35.0
1
2
3
Fig. 36.0
1
Tool Height Adjustable Armrest
Installation: Slide the arm post into the receiver, located on the
wheelchair frame, until it stops
Height adjustment:
Slide the arm rest post out of the receiver.
Adjust the position of the hight adjustment bracket (1) by
removing the screw (2) and moving it to the desired posiion.
Re-fit the screw and tighten it.
Slide the arm rest post back into the receiver, (Fig. 35.0).
Armpad Position:
The armpad position can be adjusted by relesing the screws
(3), then moving the arm pad to the desired position. Re-tighten
the screws, (Fig. 35.0).
Adjusting Armrest Receiver
The tightness of the armrest receiver can be adjusted (tightened
/loosened) by means of the 2 screws (1) - (Fig. 36.0).
Summary of Contents for Breezy BasiX2 Plus
Page 6: ...6 Rubix2 45Nm 7Nm 7Nm 7Nm 7Nm 7Nm 7Nm 45Nm 10Nm 10Nm 10Nm ...
Page 90: ...90 Rubix2 ...
Page 91: ...91 Rubix2 ...
