Sunred Flame Torch Black, Manual

Page: 16 / 58

www.sunred.nl
Do not store a spare LP-gas cylinder under or near this appliance; Never fill the cylinder beyond 80 percent full;
“Place the dust cap on the cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust
cap on the cylinder valve that is provided with the cylinder valve. Other type of caps or plugs may result in leakage
of propane ”.
PROBLEMS CHECK LIST
PROBLEMS PROBABLE CAUSES SOLUTIONS
Pilot will not light
Gas valve may be OFF Turn the gas valve ON
Tank fuel empty Refill LPG tank
Opening blocked Clean or replace opening
Air in supply system Purge air from lines
Loose connection Check all fittings
Pilot will not stay on
Debris around pilot Clean dirty area
Loose connection Tighten connection
Thermocouple bad Replace Thermocouple
Gas leak in line Check connections
Lack of fuel pressure LPG cylinder is near empty
Burner will not light
Gas pressure is low LPG cylinder is near empty
Orifice blocked Remove, clean and replace
Control not on Turn valve to ON
Thermocouple bad Replace Thermocouple
Pilot light assembly bent or
not in correct location Place pilot light in correct position and
retry
Service and Maintenance Information
lf the pilot heater fails to operate correctly, contact place of purchase or their authorised service agent for advice
and service.
DO NOT ATTEMPT REPAIRS YOURSELF.
Periodic maintenance should performed at intervals not exceeding 6 months or when obvious faults exist.
(i.e.) flame burning abnormality or burner discolouration. Flame abnormality or burner discolouration is generally
a sign of gas supply blockage or blocked burner ports.
To clean the burner ports, remove the reflector assembly by removing the three nuts at the top of the reflector.
The mesh screen may than be extracted by removing the four retention screws at the base of the mesh screen
and four screws at the top of the screen. Remove the two screws retaining the burner assembly, Rotate the burner
assembly slightly then remove the burner assembly upwards.
Care should always be taken to avoid damage to the gas piping and Piezo ignition lead.
The burner and mesh screen may than be cleaned by compressed air. Assembly is a reversal of the above
procedure.
If the pilot is blocked by debris, spider webs etc. the pilot flame may be small and the flame failure device may
have not heated up enough for the main burner to come on. If this happens it will be necessary to clean the pilot
and its gas tube.
To clean the pilot, remove the burner and pilot cover as detai1ed above, Inspect the pilot injector and tubing for
blockage. If obstructed clean with compressed air. Clean the flame failure device. Assembly is a reversal of the
above procedure.