15
③
If the areas with the strongest signals (it means the depth
indication becomes the smallest and sound becomes the largest)
are larger and the location is not accurate enough, you can keep
the location of the search coil unchangeable and exit the PP mode.
Then press the PP button again and repeat the above
①②
operation
until the signals become weaker.Then, the position of the target
has been locked. You can mark on the ground by the center of
the search coil to facilitate the digging.
8. Points of DISC and P/P Mode
DISC
You can choose other operation mode according to your needs
and experience. If there are more scrap metals in the detection
area, you can choose the DISC mode to eliminate the metals
that don’t need to be detected.
Remind you once again, when
detecting in the wild, the discrimination indication and
depth indication will deviate due to the impact of the
ground condition. The composition, size and oxidation
of the metals will all affect the indication result. It's
necessary to take these factors into consideration
before choosing to eliminate a certain metal or
determining whether there are precious metals.
Note:
Don’t eliminate the precious metals.
P/P
In fact, the sensitivity in the non-motion mode(P/P mode) is very
high. Searching metals directly through the non-motion mode(P/P
mode) is also a choice. In some regions, the ground is too narrow
to sweep search coil, you can choose the P/P mode. In the severe
mineralization or salinization region, you can sweep by using P/P
mode directly.
