Last Update 4/2/2008
7
SUNPAK S34 Heater Manual
© Techrite Controls Australia
INSTALLATION
Prior to installing y our SU NPAK infrared space
heater, the follow ing should be review ed.
Compliance w ith the follow ing should y ield
satisfactory heater operation and mi nimize
installation costs.
1. The gas inlet supply and normal operating
manifold pressure for each heater are as
follow s. For gas supply line pressure in ex cess
of 5kPa, consult w ith y our representative or
the factory. The pressure regulator supplied
w ith the appliance must be i nstalled in the
gas line for natural gas mo dels.
Gas inlet pressure Nat. Gas
LP Gas
Max imum pressure 5kPa
5kPa
Manifold pressure 1.0kPa
2.6kPa
Sunpak heaters must alw ays be operated in a
location that allow s uniform air pressure around
the heater. If only part of the heater is located in
a w ind protected zone damage to the heater or
incorrect operation may occur. Time should be
taken to observe how the w ind w ill affect the
heaters under local conditions.
•
DO NOT place articles on or against this
appliance.
•
DO NOT use or store flammable materials
near this appliance.
•
DO NOT spray aerosols in the vicinity of this
appliance while it is operating.
•
Children and adults should be alerted to the
hazards of high surface temperatures, burns
and clothing ignition.
•
Young children should be carefully supervised
when they are in the area of the appliance.
•
Clothing or other flammable materials should
not be hung from the appliance, or placed on
or near the appliance.
•
Any guard or other protective device
removed for servicing the appliance must be
replaced prior to operating the appliance.
•
Installation of appliances fitted to fixed gas
supply systems and repair of all appliances
must be carried out by a qualified service
person.
•
It is imperative that control compartment,
burners and circulating air passageways of
the appliance be kept clean.
2. The heater must be installed in a location such
that it is readily accessible for servicing and
have no restriction of air flow to the air inlet of
the heater’s casing. W hen installed indoors
(commercial installations only) minimum room
volume 200m3.
4. W hen installed outdoors this heater must be in
a covered area protected from rain
w a
ter.
5. W hen installation is complete check the
soundness of the gas connections using a
manometer or soapy w ater.
6. Fully test the appliance’s operation. If unable to
adjust correctly , contact the supplier.
MOUNTING
Each heater must be installed such that the
follow ing minimum clearance from combustibles
are maintained.
Mounting Kit
A mounting kit is supplied w ith the heater.
W hether the mounting kit is used or not, minimum
clearance from combustibles must be observed
as follow s:
WARNING: The clearances shown above are also
applicable to furniture or vehicles parked below
heaters.
Above clearances apply to models on either
natural or LPG gas.
Appliance supplied w ith 1 metre lead and
standard 3-pin plug.
Model
Input
mj/hr
Side
mm
Rear
mm
Ceiling
mm
Below
mm
S34 34mj
600
430 430 1200
Certain materials or items, when stored under or
near the appliance, will be subjected to radiant
heat and could be seriously damaged.
