ADJUSTMENTS & USAGE GUIDE
1.
If you find there is no difference between tension level 1 to level 8, please check the
connection of the
Tension Cable (N
o
. 10b)
. Please see Diagram A under Step 2.
2.
If the meter does not show numbers correctly, please check the batteries. If the meter
does not count the speed and time, please check the connections of
Upper Sensor Wire
(No. 15)
to the
Meter (No. 38)
and
Upper Sensor Wire (No. 15)
to
Lower Sensor Wire
(No. 16)
.
3.
If you have difficulty putting
Left & Right Hinge Bolts (No. 19L & No.19R)
into the
Crank Arm (No. 49)
, please try moving the
Crank Arm (No. 49)
to a different angle. *Keep
in mind the
Left Hinge
Bolt (No. 19L)
has reversed threading and must be installed by
turning
counter-clockwise
.
4.
If you hear any noise when using the machine, please check if
Left & Right Hinge Bolts
(No. 19L & No.19R)
,
Hex Bolts (No. 21)
,
Hex Bolts (No. 25)
and
Connecting Joints (No.
52)
are loose. You may remove these parts and add some lubricant oil to eliminate all noise
possibilities.
Remember to tighten all the parts securely.
5.
If it is very hard to pedal on the higher tension levels, or you hear rubbing noises, please
remove the
Left & Right Belt Cover (No. 101L & No. 101R)
, and adjust the screw seen in
the following diagram. You will need to lower the position of the screw by turning
counter-clockwise. This will keep the
Magnet Board (No. 84)
from contacting the magnetic
flywheel. Before re-installing the
Left & Right Belt Cover (No. 101L & No. 101R)
, test the
tension level 8 to ensure the magnets do not touch the flywheel.
Summary of Contents for ESSENTIAL INTERACTIVE Series
Page 3: ...2 EXPLODED DIAGRAM 1 EXPLODED DIAGRAM 2 ...
Page 16: ......
