Sunnen LBB-1660, Installation, Setup And Operation Instructions

Page: 26 / 48

COOLANT LEVEL CHECK
Monthly check level of Coolant in Coolant
Reservoir and add Coolant as required by pouring
coolant into Work Tray
(refer to Appendix A) .
Replace Coolant using ONLY Sunnen Industrial
Honing Oil or Sunnen Water-Based Coolant.
If the machine is low on coolant, order more
Sunnen Industrial Honing Oil. Do Not add
kerosene, cutting fluids, or any other fluids to
coolant that is left - it will ruin coolant. If you must
operate machine before you receive you new
coolant, temporarily drain and remove Sediment
Tray. If necessary, place a large chunk of metal in
reservoir to raise coolant level above pump inlet -
but remember this is a temporary expedient, and
remove chunk of metal when you refill reservoir.
Also, reinstall Sediment Tray.
SEDIMENT TRAY
Clean Sediment Tray as follows (see Figure 4-2) :
WARNING
Turn electrical power OFF at main buss box or
main power source when performing any
maintenance not requiring power.
1. Turn OFF all electrical power to machine.
2. Open Access Door on front of machine.
3. Push Drain Pipe up to left.
4. Grasp Sediment Tray lip, which over-hangs right
side of Reservoir and tip tray to left, allowing coolant
to drain from sludge.
5. Remove Sediment Tray and dispose of sludge. If
not cleaning Reservoir, install Sediment Tray with
lip overhanging right side of Reservoir.
6. Pull Drain Pipe down and to right.
7. Close Doors on top and front of machine.
.8. Dispose of sludge according to local codes.
COOLANT RESERVOIR
Clean Coolant Reservoir as follows (see Figure 4-2) :
1. Direct one or more Coolant Nozzles into a
separate container.
2. Press START Button, and pump coolant from
Reservoir.
WARNING
Turn electrical power OFF at main buss box or
main power source when performing any
maintenance not requiring power.
3. Press STOP Button, and turn off all power to
machine.
4. Open Access Door on front of machine.
18
FIGURE 4-3, Feed Dial
FIGURE 4-4, Honing Dial
BUSHING
FIGURE 4-2, Coolant Reservoir
CLAMP
KNOB
RESERVOIR
RETAINER
RESERVOIR
DRAIN
PLUG
SETTLEMENT
TRAY
PUMP
DRAIN PIPE
COLLAR
FEED
SCREW
FEED
DIAL
HONING
DIAL