User Manual
4 Installation Guide
21
Insert the
cable
Unscrew the terminal
by a screwdriver
Tighten the terminal
Step 5
Follow the same procedure to connect rest cables. Comb all the input
cables together with cable ties and firm them onto the cable support bar.
Appropriate cable bending space shall be ensured.
4.4.5 Output wiring and connections
The copper cable is recommended for the PVS output terminal. If an
aluminum cable is selected, a copper aluminum terminal must be used
and the specification of the aluminum cable should meet the local
technical requirements.
Lift the protective cover upwards. Then loosen the nut from water-proof
terminals.
Step 1
Insert the “DC+” cable through “DC Output (+)” terminal. Enough cable
bending space should be ensured.
Step 2
Strip off both protective and insulating layers with the help of a hand
crimping pliers. The length of cable conductor shall be approx. 25mm.
25mm
Step 3
Connect the cable to the proper DT terminal. The cable specification is
specified in
8.1 Technical Data.
