13
14
Appendix V: System Menu Setting Procedures
Note
：
When you quit and save the menu setting, please set the menu
to POO, then press the SET to RUNX, then it is OK, You also can press
‘STOP’ button to quit and save menu setting too. And then resume
power to test.
Appendix VI: Setting Menu Explanations
LP01: Working mode(0 is Continuous testing mode
，
1 is Normal working mode)
LP02
：
Auto delay time setting.(0-60, 0 is NO auto close, for example
，
3 means
barrier gate will auto close in 3 sec after opened)
LP03
：
RS485 address(0-255)(optional)
RS485 communication equipment address (barrier gate or control board)
LP04
：
Default
DP01: Max open speed range(1-16)
The highest speed when opening
DP02: Opening brake pulse duration(0-255)
The speed need to be controlled to achieve when opening to close position,
the bigger the value, the slower the speed controlled, vice verse. Default
value is 5.
DP03: The stating brake angle of opening (37-90)
The starting angle of braking when opening
DP04: Max braking strength when opening(0-10)
The strength of braking when opening
DP05: Max close speed range(1-16)
The highest speed when closing
DP06: Closing brake pulse duration(0-255)
The speed need to be controlled to achieve when closing to close position,
the bigger the value, the slower the speed controlled, vice verse. Default
value is 5.
DP07: Max braking strength when closing(0-10)
The strength of braking when closing
DP08: Default
DP10: Opening angle (0-100)
Horizontal degree is 0, when power on, barrier gate will auto close to find
0position, open to position degree is about 90 degrees. Sometimes the
degrees will more than or less than because of mechanical parts
matching or precision issues.
DP11
：
The lowest running speed(1-16)
The end speed of barrier gate opening or closing to position. The longer
the arm, the bigger the value. Normal value is 1, if too big, barrier arm
will be shake. If over loaded, can increase the value by one
DP12: First speed/Max auto revers speed.(1-16)
Closing Speed of auto finding 0 point (First power on or resume power),
also the maximum auto-revers speed. Normal value 5 or 6.
Normally, just need to adjust DP04/05/07/08 when arm is shaking in closing or
opening, others default.
Non-User Menu
NP02: Reset control board
Enter this menu, display P-H, long press button INC unitle display P-F,
then all parameters are default.
NP03: Arm detection
R UN0
Power on
0
P 0
Press SET
P 0
Press INC
1
0 0
Press SET
1
0 0
Press INC
2
0
Press SET
1
P
0
Press DEC
0
P
Press SET
R UN0
L
L
Note:
SET is Function Key
INC is Increase
DEC is Decrease
Menu in&out is P00
Menu has 3 series ：
L is Logical menu
D is Drive menu
N is Non-users menu
This is Cyclic Menu
When system in work, Digitron displays RUNX
Press ‘STOP’ to save
and quit menu
Or
