25
5.1
Motor + Motor Seat
Cut the heat-shrink tubing into 4, 1.5-2 cm for each part. Then start to assemble.
Step 1
. Take a motor, a pair of motor protective seats, and a propeller bumper of the
same color (note that two motors with the same color wire should be assembled to two
different color motor seats). Assembly them as shown below.
Note: When installing the motor seat, pull the wire up from motor bottom till through the slot at the
seat rim, in case of its being pressed in later steps (Insert an M1.2*10 self-tapping screw, Page 27)
Step 2
. Wrap the motor wire with a heat-shrink tubing. Then a motor is assembled.
Step 3
. Similarly assemble the other three motors. Now all the four motors are finished.
Black & white wire motor (M3) Red & black wire motor (M1)
Black & white wire motor (M4) Red & black wire motor (M2)
Summary of Contents for 6D-Box
Page 17: ...14 Then click Tools Processor ATMega328 5V 16MHz ...
Page 32: ...29 ...
