20
2.
Similarly, check the phase of
PITCH
,
ROLL
, and
YAW
and invert the phase it necessary.
PITCH
: The value should increase when you push the rocker arm up.
ROLL
: Push the rocker arm left to right and the value should increase accordingly.
YAW
: Same with ROLL, push the rocker arm left to right and the value should increase.
If any of the four channels goes wrong, just invert its phase.
4.3
Gyroscope and Accelerator Calibration
4.3.1
Calibrating Gyroscope
Place the flight control board as flat as possible. Pull the throttle and elevator to lowest and
rudder to the leftmost. The blue LED on the flight control board will blink for about 2 seconds
and then stop. So the calibration is done.
For throttle at the right hand, pull the rocker arms as below:
Kind reminder: When pulling the throttle to lowest, you may first pull the elevator to the
lowest and then the rudder to left.
For throttle at the left hand, pull the rocker arms like this:
Summary of Contents for 6D-Box
Page 17: ...14 Then click Tools Processor ATMega328 5V 16MHz ...
Page 32: ...29 ...
